Remote Control - Yamaha RXV-1700 Bedienungsanleitung

■ Remote control

Problem
The remote control Wrong distance or angle.
does not work or
function properly.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
The operation mode selector is set
incorrectly.
The remote control code was not correctly
set.
The library code of the remote control and
the remote control ID of this unit do not
match.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
The remote control The batteries of this remote control and/or
does not learn new the other remote control are too weak.
functions.
The distance between the two remote
controls is too much or too little.
The signal coding or modulation of the
other remote control is not compatible
with this remote control.
Memory capacity is full.
■ HDMI
Error message
The number of the connected HDMI
DEVICE OVER
components is over the limit.
HDCP ERROR
HDCP authentication failed.
Cause
The remote control will function within a maximum
range of 6 m and no more than 30 degrees off-axis
from the front panel.
Reposition this unit.
Replace all batteries.
Set the operation mode selector correctly.
When operating this unit, set it to the AMP position.
When operating the component selected by the input
selector button, set it to the SOURCE position.
When operating the TV set in the DTV or PHONO
area, set it to the TV position.
Set the remote control code correctly using
"LIST OF REMOTE CONTROL CODES" at the end
of this manual.
Try setting another code of the same manufacturer
using "LIST OF REMOTE CONTROL CODES" at
the end of this manual.
Match the remote control ID of this unit with the
corresponding remote control library code.
Program the necessary functions independently into
the programmable buttons using the Learn feature.
Replace the batteries.
Place the remote controls at the proper distance.
Learning is not possible.
Delete other unnecessary functions to make room for
the new functions.
Cause
Reduce the number of the connected HDMI
components.
Check that the connected HDMI components support
the HDCP copy protection standards.
TROUBLESHOOTING
Remedy
Remedy
See
page
9
—
9
—
96
96
97, 111
98
9
98
—
103
See
page
—
—
119
En