Yamaha RXV-1700 Bedienungsanleitung Seite 115

4
Press the numeric buttons to enter the
four-digit remote control code for the input
area you want to use.
CLASSICAL LIVE/CLUB
1 2
STEREO SUR. DECODE
5 6
9 0
Remote control AMP codes
Select one of the following codes to set the remote control
AMP code for the input area you want to use.
AMP library
code
Function
(remote control
setting)
2001 To operate this unit using the
(initial setting) default code.
To operate this unit using an
2002
alternative code.
Note
You need to set the corresponding remote control AMP ID
(see page 111).
5
Press ENTER to set the number.
"OK" appears in the display window if setting was
successful.
"NG" appears in the display window if the setting
was unsuccessful. In this case, start over from step 1.
A/B/C/D/E
6
Press LEARN again to exit from the setup
mode.
LEARN
ENTERTAIN MOVIE
3 4
SELECT EXTD SUR.
8
7
Remote
control AMP
ID
ID1
(initial setting)
ID2
PRESET/CH
ENTER
■ Setting remote control tuner ID
1
Set the operation mode selector to AMP or
SOURCE and then press TUNER on the
remote control to select the tuner to change
the remote control ID.
AMP
SOURCE
TV
or
AMP
SOURCE
TV
2
Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object and
the l / h repeatedly until "L;TUN" and
"TUNER" appear in the display window on
the remote control.
LEARN
Notes
• Be sure to press and hold LEARN for at least 3 seconds,
otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 1.
3
Press ENTER.
The four-digit code set for the selected input area
appears in the display window on the remote control.
A/B/C/D/E
ADVANCED SETUP
TUNER
PRESET/CH
ENTER
A/B/C/D/E
PRESET/CH
ENTER
113
En