Yamaha RXV-1700 Bedienungsanleitung Seite 111

INPUT
or
AMP
SOURCE
TV
Select TUNER as the input source to use the TUNER
features in the selected zone. For details about the TUNER
operations, see "FM/AM TUNING" on page 54.
Note
The selected input source is shared across all zones.
y
You must complete this step within 5 seconds while the selected
zone flashes in the front panel display. Otherwise, the currently
selected zone mode is automatically canceled. In this case, press
ZONE CONTROLS on the front panel again.
■ Adjusting the volume level of Zone 2 or
Zone 3
Rotate VOLUME on the front panel (or press
VOLUME +/– on the remote control) to adjust the
volume level of the selected zone.
VOLUME
y
Press MUTE on the remote control to mute the sound output to
the selected zone.
Note
When you use the external amplifiers in Zone 2 or Zone 3,
VOLUME +/– can be used only when "ZONE2 VOL" or
"ZONE3 VOL" is set to "VAR" in "ZONE SET" (see page 93).
PHONO TUNER CD MULTI CH IN
V-AUX/DOCK MD/TAPE
CBL/SAT CD-R
DTV VCR 1 DVR/VCR 2 DVD
+
or
VOLUME
–
USING MULTI-ZONE CONFIGURATION
■ Adjusting the balance of the speaker
level in Zone 2 or Zone 3
Press TONE CONTROL repeatedly to select
"BALANCE" and then rotate PROGRAM on the
front panel to adjust the balance of the front left
and right speaker level of the selected zone.
TONE
CONTROL
■ Adjusting the tonal quality of Zone 2 or
Zone 3
Set the operation mode selector to AMP and then
press CH +/– on the remote control to adjust the
high-frequency response (TREBLE) or
TV VOL +/– to adjust the low-frequency response
(BASS) respectively.
AMP
SOURCE
TV
y
You can also adjust the tonal quality of Zone 2 or Zone 3 by using
TONE CONTROL on the front panel. For details, see "Adjusting
the tonal quality" on page 50.
Note
Check that "ZONE 2" or "ZONE 3" is displayed in the display
window of the remote control before you adjust the tonal quality
of the corresponding zone (see page 108).
PROGRAM
+
TV VOL
–
BASS
+
CH
–
TREBLE
109
En