Controlling External Components; Setting Remote Control Codes - Yamaha RDX-E700 Bedienungsanleitung

CONTROLLING EXTERNAL COMPONENTS

CONTROLLING EXTERNAL COMPONENTS
In addition to controlling this unit, you can operate external components with the remote control for the DVD receiver by
selecting the appropriate remote control code (refer to "LIST OF REMOTE CONTROL CODES" at the end of this
manual).
Note
Depending on the product, the remote control may not be able to operate the external component. In this case, use the remote control
supplied with the product.

Setting remote control codes

You can set a remote control code for TV on the TV
button on the remote control, and a remote control code
for Cable TV or Digital Broadcast Satellite tuner on the
AUX button on the remote control.
STANDBY/ON
POWER
TV
1 2 3
5 6 7
DIMMER SLEEP
9 0
+
A-B
REPEAT
TV CH
FREQ/TEXT
–
PROG
PTY SEEK
MODE START
TV INPUT RANDOM
PRESET
d uPRESET
GUI MENU
ENTER
TOP MENU
SET UP
TV VOL VOLUME
MUTE
+ +
– –
NIGHT
EQ TV DVD/CD
DIRECT AUX TUNER
SUBTITLE ANGLE ZOOM AUDIO
42
4
Number
buttons
8
PROG
/RETURN
TV
AUX
1
Press TV or AUX to set the input source of
the DVD receiver to the component you want
to operate with the remote control.
2
While holding down PROG
then while still holding down PROG, press
the number buttons to enter the three-digit
remote control code (refer to "LIST OF
REMOTE CONTROL CODES" at the end of
this manual) for the manufacturer of your
component.
3
Refer to "Available operations" (page 43) and
try one of the button operations for your
component to check that the setting is
working properly.
If the button operation does not work properly, the
remote control code may be incorrect. In this case,
perform step 1 again.
Notes
• Even if you set a remote control code, it will be cleared about
two minutes after the remote control batteries run out. In this
case, store remote control codes again after replacing the
batteries. (Be careful not to press the remote control buttons
while replacing the batteries. Doing so may clear the settings.)
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
press TV or AUX,
,