Option Menu; Display Settings - Yamaha RXV-1700 Bedienungsanleitung

CUSTOMIZING THIS UNIT (MANUAL SETUP)

4 OPTION MENU

Use this menu to adjust the optional system parameters.
4 OPTION MENU 1/2
. A)DISPLAY SET
B)MEMORY GUARD
C)AUDIO SELECT
D)DECODER MODE
[ ]/[ ]:Up/Down
[ENTER]:Enter

■ Display settings

Note
Use "V-RESET" in "ADVANCED SETUP" to set the parameters
in "DISPLAY SET" (except "DIMMER", "SHORT MESSAGE",
"ON SCREEN" and "FL SCROLL") to the factory presets (see
page 112).
A)DISPLAY SET
. DIMMER;;;;;;;;;;0
OSD SHIFT;;;;;;;0
GRAY BACK;;;;AUTO
V CONV.;;;;;;;;ON
[ ]/[ ]:Up/Down
p
[ ]/[ ]:Adjust
Dimmer DIMMER
Use this feature to adjust the brightness of the front panel
display.
Control range: – 4 to 0
Control step: 1
• Press l to make the front panel display dimmer.
• Press h to make the front panel display brighter.
OSD shift OSD SHIFT
Use this feature to adjust the vertical position of the OSD.
Control range: –5 (upward) to +5 (downward)
Control step: 1
Initial setting: 0
• Press l to raise the position of the OSD.
• Press h to lower the position of the OSD.
Gray back GRAY BACK
Use this feature to display a gray background in your
video monitor when there is no video signal being input.
Choices: AUTO, OFF
• Select "AUTO" to display a gray background in your
video monitor when there is no video signal being
input.
• Select "OFF" not to display a gray background in your
video monitor.
90
En
4 OPTION MENU 2/2
. E)PARAM. INI
F)ZONE SET
G)DOCK SET
[ ]/[ ]:Up/Down
[ENTER]:Enter
A)DISPLAY SET
[
Notes
• Depending on the video signals being input or the system
setting of your video monitor (NTSC or PAL), the OSD may be
displayed abnormally. In such cases, set "GRAY BACK" to
"OFF".
• Even when "GRAY BACK" is set to "OFF", the OSD may not
be displayed correctly depending on the conditions of the
picture.
V CONV.
Video conversion
Use this feature to set whether to convert the video signals
input at the VIDEO, S VIDEO and COMPONENT
VIDEO jacks.
Choices: ON, OFF
• Select "ON" to convert composite, S-video and
component video signals interchangeably and up-
convert composite and S-video and component video
signals to HDMI video signals.
• Select "OFF" not to convert any signals.
Notes
• This unit does not convert 480 line video signals and 576 line
video signals interchangeably.
• The converted video signals are only output at the MONITOR
OUT jacks. When recording a video source, you must make the
same type of video connections between each component.
• When composite video or S-video signals from a VCR are
converted to component video signals, the picture quality may
suffer depending on your VCR.
• Set "V CONV." to "ON" to display the sound field parameter
display and short message display.
• Unconventional signals input at the composite video or S-video
jacks cannot be converted or may be output abnormally. In such
cases, set "V CONV." to "OFF".
• When non-standard video signals (such as video signals from a
game console) are input, this unit may not convert the signals
even if you set "V CONV." to "ON".