Operation - Abicor Binzel TCS-Compact Betriebsanleitung

TCS-Compact

7 Operation

NOTICE
• As the TCS-Compact cleaning station is integrated into a welding system, the operating instructions for
• Ensure that the TCS-Compact is only ever operated when using the protective device supplied.
• The system may only be operated by qualified personnel (in Germany, see TRBS 1203).
1 Switch on the robot control system.
2 Start the welding process.
3 Stop the welding process.
8 Putting out of operation
NOTICE
• As the TCS-Compact cleaning station is integrated into a welding system, the procedure for putting it
• When putting the system out of operation, ensure that the procedures for switching off each of the
1 Switch off the robot control.
9 Maintenance and cleaning
Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free operation.
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly, and repair work:
• Switch off the power supply.
• Close the compressed air supply.
Electric shock
Dangerous voltage due to defective cables.
• Check that all live cables and connections are properly installed and undamaged.
• Replace any damaged, deformed, or worn parts.
NOTICE
• Maintenance and cleaning work may only be carried out by qualified personnel (in Germany, see
• Always wear your personal protective clothing when performing maintenance and cleaning work.
The TCS-Compact cleaning station is virtually maintenance free. However, it is in your interest to regularly
clean and assess the mechanically stressed parts in order to maintain the system's value and ensure it
remains fully functional.
the welding components, such as the welding torch and robot control system, must be observed
during operation.
out of operation depends on the robot control system.
welding system components are observed.
DANGER
DANGER
TRBS 1203).
7 Operation