Abicor Binzel TCS-Compact Betriebsanleitung Seite 60

6 Putting into operation
6.3.4 Mounting the reamer
1
6
7
6
5
1
Reamer
2
AF17 fork wrench
3 AF21 fork wrench
Fig. 16
Mounting the reamer
NOTICE
• When changing the reamer, only use tools with a compatible width across flats. AF21 motor
protection cap (6), AF17 reamer.
• Ensure that the bellows (5) is in the correct position.
1 Attach the motor protection cap (6).
2 Attach the reamer (1) to the pneumatic motor (4).
3 Use the AF17 fork wrench (2) to tighten the reamer (1) (minimum tightening torque 20 Nm) while
holding it in place with an AF21 fork wrench (3).
NOTICE
• For easier assembly, the pneumatic motor should be in the lower clamping and stroke position.
4
Pneumatic motor
5
Bellows
Fig. 17 Bellows position on page EN-25
TCS-Compact
6
Motor protection cap
7
Motor output shaft
1
2
3
4