Height Adjustment - Abicor Binzel TCS-Compact Betriebsanleitung

TCS-Compact

6.4.1 Height adjustment

4
5
9
6
4 Gas nozzle
5 Reamer
Fig. 20 Height adjustment
NOTICE
• The device has to be depressurized during set-up.
1 Use the AF6 Allen key to loosen the M8x45 clamping screws (6). While doing this, hold the pneumatic
2 Move the pneumatic motor (8) to the upper stroke position (Fig. A) (this can be done manually).
3 Move the pneumatic motor (8) in the motor bracket (9) upward until the front of the reamer (5) touches
4 Tighten the M8x45 clamping screws (6) on the motor bracket (9) (minimum tightening torque 20 Nm).
Fig. 19 Setting up the pneumatic motor on page EN-26
Lower stroke position
A
6 M8x45 clamping screws
8 Pneumatic motor
motor (8) securely in position.
the front of the gas nozzle (4) (Fig. B).
Upper stroke position
B
9 Motor bracket
6 Putting into operation
4
5
Reamer
limit stop
8