Abicor Binzel TCS-Compact Betriebsanleitung Seite 61

TCS-Compact
Fig. 17 Bellows position
6.3.5 Setting up the clamping position
NOTICE
• Only use clamping prisms and reamers adjusted to the gas nozzle diameter.
1
Clamping prism
2 Gas nozzle
Fig. 18 Setting up the clamping position
1 Position the torch with the gas nozzle (2) concentrically to the tool axis (reamer axis) over the cleaning
2 Approach the clamping position. Ensure the cylindrical part of the gas nozzle (2) lies evenly against the
Fig. 18 Setting up the clamping position on page EN-25
1
3
Cleaning station
4 Gas nozzle clamping device
station (3).
clamping prism (1).
2
Tool axis
5
5
Clamping position
6 Putting into operation
3
4