Abicor Binzel TCS-Compact Betriebsanleitung Seite 58

6 Putting into operation
6.3.2 Wire cutting device
1
8
7
1 Countersunk screw M5x20
2 Protection plate
3 Welding torch
Fig. 14 Wire cutting device
1 For better access, loosen the protection plate and move it backwards.
2 Move the welding torch to the cutting position.
NOTICE
• Note the desired stick-out length.
3 Move the free wire end to the fixed cutter (lower cutting edge).
4 Once you have programmed the desired cutting length, the protection plate must be moved forward
again. The gap between the fixed cutter and the protection plate should be < 4 mm.
NOTICE
• If the cutting plates reach their wear limit (bad cutting quality, cutting device jams, wire is no longer
cut, etc.), the cutting plates do not need to be immediately replaced.
• Program a new cutting position within the area of the cutting plates.
2
4 Stick-out (SO)—free wire end
5 Guide plate for wire scraps
6 Moving cutting plate (not visible)
TCS-Compact
3
4
5
6
7 Fixed cutting plate
8 Container for wire scraps