Weidmuller Power Monitor Handbuch Seite 224

Communications
Reset integral power
◊ This resets all integral power.
◊ To reset integral power, an operator's code should be defined, but this will not be stored and the code is
fixed to '0'. It is only available only by pressing the <MODE> key (programming key).
• Command from Master; control code 1AH
68H A0 A1
Transmission address
⇒
continue
level (33H fix)
• Response from Slave (normal)
68H A0 A1
Abnormal command from Slave
Control code (C); C0H (Response from slave is abnormal.) + Control code when error occurs.
68H A0 A1
102
A2 A3 A4 A5
PA P0
Authorization Password
(P2: 33H fix)
A2 A3 A4 A5
A2 A3 A4 A5
Contents of
error code
68H 1AH
Control code
⇒
P1 P2
continue
⇒
continue
68H 9AH 00H CS
68H C
Control code
Bit flag
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
08H
C0 C1 C2 C3
Operator's code (33H fix)
16H
01H ERR
Error code
(bit flag)
Contents
Not support
Not support
Not support
Not support
Impossible to change
transmission speed
Password mistake
No request data
Other errors
1435710000/01/05.13
⇒
continue
CS 16H
16H