Weidmuller Power Monitor Handbuch Seite 153

Settings
Primary side current of CT
Set the primary side current of CT used.
Enter the primary side current of CT that is set at CT type setting.
Primary side current of using CT is 400 A:
VT ratio
Select the voltage input method, input voltage directly or uses a voltage transformer
(VT: secondary side rating 110 V) and set VT ratio.
Input directly without VT:
Use VT:
Note
When the input voltage is under 3 V (VT ratio = 1), [0.0] is displayed and no measurements are made.
1435710000/01/05.13
CT-1
Press <ITEM/∆>, <SHIFT/∇> to make the setting.
[Set range] 1 to 4000 (initial:5)
Increase
Decrease
[400]
VT
Press <ITEM/∆>, <SHIFT/∇> to make the setting.
[Set range] 1.00 to 600.00 (initial:1.00)
Increase
Decrease
[1.00]
[1.01 to 600.00]
31