Error Codes - Weidmuller Power Monitor Handbuch

Communications
9.3.3

Error codes

Basic procedure errors
Error code Error name
40H Bcc error
41H Format error
42H No support error
43H Procedure error
Application error
Error code Error name
60H Parameter error
61H Data error
62H Registration error
Self-diagnostic error
Error code Error name
45H Operation error
76
Explanation
A Bcc error occurred in the command data.
A command message was sent that does not fit the transmission
format.
A command was sent that is not supported.
Delimiter with multiple frames was sent.
The response shall be multiple frames.
Explanation
The data code is not "D".
Word no. is specified without decimal. (0000F etc.)
The starting word no. is bigger than the ending word no.
Writing data has a code that is not hexadecimal.
Too many registrations have been entered (more than 17).
"MD" command was sent in the event of an already existing
registration.
"MG" command was sent when registration has not been entered.
Explanation
At "WD" command, writing data has exceeded the range of data
register.
1435710000/01/05.13