Settings; Settings For Power Measurement - Weidmuller Power Monitor Handbuch

Settings

7.4 Settings
Make setting before measuring
Select setting item with <ITEM/∆> and press <SET>, the value will flash.
Set with <ITEM/∆> and <SHIFT/∇>.
Select [YES] in the confirmation window and press <SET> to confirm the setting values.
7.4.1

Settings for power measurement

Phase/wire system
Select the phase/wire system to be measured.
Press <ITEM/∆>, <SHIFT/∇> to select the phase/wire system.
[Set list] 1P2W, 1P3W, 3P3W, 3P4W (initial: 1P2W)
* If the system settings do not match those of the measurement system, measurements will not be accurate.
CT type
Select using CT type (secondary side current).
To use CT with secondary side current 5 A:
To use CT with secondary side current 1 A:
30
SYST
CT-T
Press <ITEM/∆>, <SHIFT/∇> to select CT type.
[Set list] 5 (5 A), 1 (1A) (initial: 5)
[5]
[1]
1435710000/01/05.13