Connections; Scsi Interface Connection To The Computer - Sony UP-D50 Gebrauchsanweisung

Connections

The UP-D50 can be connected to computers and
peripheral devices equipped with a SCSI interface.
Notes
• Before making connections, always turn off all
connected devices.
• Connect the power cord last.
• Refer to the operating manual of each device for
details of connections between the printer, computer
and peripherals.
SCSI Interface Connection to the
Computer
Connect the printer to a SCSI interface-equipped
computer or peripheral device.
Notes
• SCSI cable connectors should be firmly mated at each
end.
• The total length of SCSI cables connected to a single
host computer should be no longer than 3 meters.
• When connecting only the printer to a single host
computer, the SCSI cable should be no longer than 1
meter.
Computer
SCSI Cable
(sold separately)
To SCSI
connector
DIP Switch
To AC power output
a) When connecting at the end of the SCSI bus, set the
internal terminator ON. ("DIP Switch Settings" on page 8)
To ~AC IN
terminal
a)
Power Cord (supplied)
Note
The proper SCSI cable to use depends on the connected
computer or peripheral device. Refer to the machines'
manuals for details.
When turning power on
Turn on any peripheral devices before turning the
computer on. Make sure that every device in the SCSI
chain is turned on.
Note
To print, a driver is required that corresponds to the
hardware environment in which the printer is to be used.
Connections 9