Connections - Sony UP-DR100 Gebrauchsanweisung

Connections

The UP-DR100 can be connected to computers and
peripheral devices equipped with a SCSI interface.
Notes
• Before making connections, always turn off all
connected devices.
• Connect the power cord last.
• Refer to the operating manual of each device for
details of connections between the printer, computer
and peripherals.
• SCSI cable connectors should be firmly mated at each
end.
• The total length of SCSI cables connected to a single
host computer should not be longer than 3 meters.
• When connecting only the printer to a single host
computer, the SCSI cable should not be longer than 1
meter.
• To print, a driver is required that corresponds to the
hardware environment in which the printer is to be
used.
36
Connections
Computer
SCSI Cable
(not supplied)
To SCSI
connector
To -AC IN
terminal
Power Cord (supplied)
To AC power output
a) When connecting the printer at the end of the SCSI bus,
set the internal terminator to ON. ("DIP Switch Settings"
on page 35)
Note
The proper SCSI cable to use depends on the connected
computer or the peripheral device. Refer to the manuals
for details.
When turning power on
Turn on any peripheral devices before turning the
computer on. Make sure that every device in the SCSI
chain is turned on.
To disconnect
a)
DIP Switch