Connections; Making Connections For Storing Video Images - Sony UP-2100P Gebrauchsanweisung

Connections

To enable printing, video equipment to act as an input signal source, and a video
monitor to display images or menus must be connected.
The following diagrams illustrate how to make the input, output and remote control
connections. Use this as a guide when connecting the necessary signals to and from
the equipment to be used for printing.
Notes
• Turn off the power of each device before attempting to make any connections.
• Connect the AC power cord last.

Making Connections for Storing Video Images

Connect the video equipment providing the video images to be printed.
Connect the video equipment which will be used in actual printing, using the
following diagram as a guide.
Before connecting the video equipment, see "Important safeguards/notices for use
in the medical environment" on page 2.
to S-VIDEO output
connector
Connecting cable (with
DIN 4-pin connectors)
YC-15EV
to S-VIDEO INPUT
INPUT
S-VIDEO VIDEO
REMOTE
1 2
Video equipment
to composite video output
connector
75-ohm coaxial cable
with BNC connectors
to VIDEO INPUT
OUTPUT
S-VIDEO VIDEO
AC power cord
(supplied)
Installation and Adjustment
UP-2100 P
~
AC IN
to AC IN
to wall outlet
53