Adjustments - Sony UP-D50 Gebrauchsanweisung

Notes
When printing with the COPY button, you must wait for
printing to finish before switching the printer on-line.
If you cannot print
• Printing cannot be initiated with the COPY button
when the printer is on-line. Press the ONLINE button
to switch the printer off-line.
• The printer cannot print when an error or warning
message is displayed on the LCD. Please refer to
"Error and Warning Messages" on page 26.
• When the printer is turned off, transferred images are
erased from memory, so there is nothing to print when
the COPY button is pressed. Send the image to the
printer again to print it.
To interrupt printing
Press the ONLINE button to switch the printer offline,
then press the QTY RESET button.
The currently printing page finished printing, and when
the paper is ejected, the printer enters standby mode.
When multiple copies have been specified, the number
of copies to print is cleared when the printer enters the
standby mode.
If colors do not print properly
Print color can be optimized by adjusting the printed
image color tones and image quality. See "Adjusting
Image Quality" on page 16.
If the printer runs out of paper
Printing resumes automatically when the paper tray is
refilled (see "Loading Paper" on page 11).
Storing printed images
• Avoid exposure to direct sunlight, or conditions of
high temperature and high humidity, which could
cause the colors to fade.
• Avoid applying tape to a printed picture, and avoid
contact with plastic objects such as erasers and desk
mats.

Adjustments

Printersettings are made as follows from three menu
screens below.
Menu Settings
Screen
COLOR • Adjust printer image color tone,
ADJUST
gradation and sharpness
PRINT • Select the image to be reprinted.
SETUP
• Set the number of copies to be
reprinted.
• Select lamination pattern
• Adjust density of neutral tints
• Print the gray balance adjustment
pattern
• Adjust gray balance
• Check number of printed pages
SYSTEM • Enable/disable display of remaining
SETUP
ribbon amount
• Enable/disable operating and alarm
sounds
• Adjust printer's LCD contrast
Ref.
page
16
14
14
17
18
20
19
20
21
22
23
Adjustments 15