Connections; Connecting The Computer - Sony UP-D70A Bedienungsanleitung

Connections

Connecting the Computer

10
Preparation
The printer connects to a Windows computer via either the SCSI interface or the
parallel interface. The printer can also connect to a Macintosh computer via the
SCSI interface.
Notes
• Before connecting the cable, make sure to turn off the power switches on your
computer and any peripheral equipment.
• Be sure to connect one printer to one computer. Do not connect two computers to
the printer.
• Do not connect the computer equipped with the SCSI interface and parallel
interface to both of the PARALLEL DATA IN connecter and SCSI connecter of
the printer at the same time.
• Grasp the connector at the end of the cable, and firmly insert it into the socket.
• The total length of the SCSI cabling used with a single-host computer should be
less than 6 meters.
• The parallel data cable should be less than 3 meters long and should confirm to
Centronics specifications for printer cables.
• Avoid sending parallel data to the printer while the printer is processing SCSI
commands, and vice versa.
• Cable connection requirements vary depending on computers and peripherals.
For the details of your installation, please refer to the manuals for your computer
and peripherals.
When connecting a printer via the parallel interface
Parallel data cable
(shielded type)