I) Attaching And Fastening The Vehicle Body; J) Controlling The Vehicle - Reely Firestar Bedienungsanleitung

The speed controller emits several audio signals to indicate that it is ready for use. Also see the provided operating
instructions of the speed controller. Now check the drive and steering functions of the vehicle; also see chapter 9. j).

i) Attaching and fastening the vehicle body

Push the aerial tube from the bottom of the body through the designated opening. Now put the vehicle body on the
holders and fasten it using the safety clips previously removed.
Your vehicle is now ready for its first test run!

j) Controlling the vehicle

Operate the throttle very carefully and do not drive too fast at the beginning until you get used to how the
vehicle responds. Never switch off the transmitter when the vehicle is moving!
Do not make quick jerky movements with the operating elements of the remote control.
If the vehicle shows a tendency to pull towards the left or the right, set the steering trim on the transmitter
accordingly.
When switching between forward and reverse gear, the throttle/brake lever must be put in neutral position
shortly (approx. 1 second).
If the throttle/brake lever is moved from forward to reverse directly, the brake function of the drive is activated
(vehicle will NOT reverse!).
Examples:
1. Let go of throttle/brake lever; vehicle rolls to a
halt or does not move; if necessary, adjust the
"TH.TRIM" control
2. Drive forward, pull the throttle/brake lever
towards the handle
3. Drive forward and then brake (vehicle slows
down; does not roll to a halt slowly); push
throttle/brake lever away from the handle
without stopping
4. Drive forward and then reverse; wait for a short
time before reversing; throttle/brake lever must
be in neutral position for a short time (approx.
1 second)
32
Wait briefly