H) Checking Drive And Steer Functions; I) Attaching And Fastening The Vehicle Body - Reely Massive Bedienungsanleitung

h) Checking drive and steer functions

Before using the model, always check if the remote control settings are correct and if the vehicle responds to the
remote signals correctly.
As described in chapter 9. f), the vehicle has to be placed on a suitable support (e.g. starter box) so that
the wheels can turn freely and do not touch the ground.
• Adjust the trim for the drive (see chapter 7, pos. 10) so that the drive does not move when the throttle (13) is
released.
• Adjust the trim for the steering (see chapter 7, pos. 9) so that the front wheels are straight when the control wheel (8)
is released.
• Turn the dual-rate control completely to the right to reach the maximum steering angle. The control can be adjusted
later as desired when driving the vehicle.
• Turn all four control dials "EPA-TH" and "EPA-ST" completely to the right.
• Check if the steering responds correctly to the control wheel (8). Should the response be in the opposite direction
(wheel turned left, steering turns right), put the reverse switch (3) in the other position.
• Check if the drive responds correctly to the throttle (13). If necessary, use the reverse switch (4) to invert forward/
reverse drive. Please read chapter 9. j) in this respect.
• Use the two "EPA-ST" control dials to set the steering end point to the left and to the right. As described in chapter
7, the end point of the servo should correspond exactly with the end point of the steering mechanism. This relieves
the strain on the servo gear and saves power.

i) Attaching and fastening the vehicle body

Push the aerial tube from the underside of the body through the designated opening. If there is no opening, you can
easily make one at the appropriate spot using a suitable tool.
Now put the vehicle body on the holders and fasten them using the holding clips previously removed.
Your vehicle is now ready for its first test run!
34