Unpacking And Assembly; Fitting The Steering Wheel - GGP ITALY SD98 Gebrauchsanweisung

3. UNPACKING AND ASSEMBLY

For storage and transport purposes, some com-
ponents of the machine are not installed in the
factory and have to be assembled after unpack-
ing. Follow the instructions below.
IMPORTANT
plied without engine oil or fuel. Before starting
the engine, fill with oil and fuel following the in-
structions given in the engine manual.
WARNING!
pleting the assembly should be done on a
flat and stable surface, with enough space
for machine handling and its packaging,
always making use of suitable equipment.
3.1 UNPACKING
When unpacking the machine, take care to
gather all individual parts and fittings, and do
not damage the cutting deck when taking the
machine off the pallet.
The packaging contains:
– the machine;
– the steering wheel;
– the dashboard cover;
– the seat;
– the battery;
– the side discharge chute
– an envelope containing:
– the operator's manuals and documents,
– steering wheel assembly parts,
– nuts and bolts to assemble the seat and the
supplied side discharge chute
– the connection screws for the battery cables
– 2 starter keys,
– 1 spare 10 A fuse.
NOTE
the cutting deck, raise it to its maximum height
and take utmost care when taking the machine
off the pallet.
Hydrostatic transmission
To make it easier to get the machine off the
pallet and to move it, the drive disengage
lever should be put in position «B» (
Disposal of the packaging should be done in
accordance with the local regulations in force.
The machine is sup-
Unpacking and com­
o prevent damage to
4.33).

3.2 FITTING THE STEERING WHEEL

• Type "I" Steering Wheel
Put the machine on a flat surface and straighten
up the front wheels.
Mount the hub (1) on the shaft (2), making sure
that the plug (3) is correctly fitted into the hub
seat.
2
3
Fit the dashboard cover (4) clicking the seven
fasteners into place.
Fit the steering wheel (5) onto the hub (1) with
the spokes directed towards the seat.
8
7
6
5
1
Fit the spacer (6) and fasten the steering wheel
in place using the screws supplied (7), in the
indicated order.
Fit the steering wheel cover (8) clicking the
three fasteners into place.
4
1
EN 7