Maintenance; Safety Recommendations; Routine Maintenance - GGP ITALY SD98 Gebrauchsanweisung

6. MAINTENANCE

6.1 SAFETY RECOMMENDATIONS

WARNING!
doing maintenance work, take out the igni­
tion key and read the relevant instructions.
Wear adequate clothing and work gloves
whenever your hands are at risk.
WARNING!
chine with worn or damaged parts. Faulty
or worn­out parts must always be replaced
and not repaired. Only use original spare
parts: The use or non­original and/or in­
correctly fitted parts will compromise the
safety of the machine, may cause acci­
dents or personal injuries for which the
Manufacturer is under no circumstance li­
able or responsible.
IMPORTANT
oil, fuel, batteries or other pollutants in unau-
thorised places!
WARNING!
maintenance operations not described in
this manual must be carried out by your
Dealer or a specialized Service Centre.
Operation
1. MACHINE
Check of fastening and sharpness of blades
Blade replacement
3)
Transmission belt check
Transmission belt replacement
Blade belt check
3)
Blade belt replacement
Drive adjustment and check
Blade brake and engagement check
Bolt and screw check
General lubrication
4)
2. ENGINE
1)
Engine oil change
Air filter cleaning and check
Air filter replacement
Fuel filter check
Fuel filter replacement
Spark plug contacts check and cleaning
Spark plug replacement
Before cleaning or
Never use the ma­
Never dispose of used
Any adjustments or
3)
3)
2) 3)
2) 3)
3)
3)
Both have the necessary knowledge and
equipment to ensure that the work is done
correctly without affecting the safety of the
machine.
All and any operations performed in unau­
thorised centres or by unqualified persons
will totally invalidate the warranty and all
obligations and responsibilities of the
manufacturer.
You must go to a specialised Service
Centre or contact your Dealer if the follow­
ing are malfunctioning:
– the brake;
– the engagement and stop of the blades;
– the drive engagement in forward and in
reverse gears.

6.2 ROUTINE MAINTENANCE

The table is to help you maintain your machine's
safety and performance. It summarises the main
interventions to be made and the frequency
applicable to each of them.
The boxes at the side are for you to mark the
date or number of working hours at which the
intervention was made.
Hours
25
100
25
–
25
–
25
25
25
25
.....
.....
.....
.....
.....
.....
.....
Completed (Date or Time)
EN 21