Philips GC536 Bedienungsanleitung Seite 42

EN
Problem
The appliance
produces no steam
or irregular steam.
Water droplets drip
from the steamer
head or the appliance
produces a croaking
sound.
An excessive amount
of water drips out
of the steamer head
when the appliance is
heating up.
Water leaks out from
the steamer base.
A few water droplets
come out when
the water tank is
detached.
42
Possible cause
The steamer has not
heated up sufficiently.
Steam has condensed in
the hose.
The water level is below
the MIN level indication
or the tank is not
inserted properly.
Too much scale has built
up in the appliance.
You have left the
steamer head and/or
the steam supply hose in
horizontal position for a
long time.
When the hose forms a
U-shape, condensation
in the hose cannot flow
back into the water tank.
The water in the
appliance is dirty or
has been left inside the
appliance for a long time.
You have not closed the
water tank cap or easy
rinse knob securely.
The water tank is not
inserted properly.
This is part of the water
inlet design.
Solution
Let the appliance heat up for
approximately 45 seconds. U se
for faster heat up (GC536 only).
Lift the steamer head to straighten
the hose vertically. This allows any
condensation t o flow back.
Refill the water tank and insert it
properly until you hear a "click"
sound.
Perform easy rinse process. Refer
to section.
Lift the steamer head to straighten
the hose vertically. This allows any
condensation to flow back.
Lift the steamer head to straighten
the hose vertically. This allows any
condensation to flow back.
Perform easy rinse process. Refer
to section.
Close the water tank cap and easy
rinse knob securely.
I nsert the tank properly until you
hear a "click" sound.
This is normal.