Preparation For Installation - Bosch FWA 4650 Erstinbetriebnahme Und Nachrüstung

4.

Preparation for installation

4.1 Scope of delivery
i
The scope of delivery varies depending on the versi-
on.
1. Unpack the WLAN-Box.
2. Check the scope of delivery against the delivery slip.
"
This completes checking of the scope of delivery.
4.2 Qualifications
!
Commissioning of the WLAN-Box must be performed
by qualified service personnel.
4.3 Measurement bay
i
Further information on the measurement bay can be
found in the document Commissioning of FWA 4630
1690706006.
1. Check the level of the measurement bay.
2. Adjust the level if necessary.
"
This completes checking of the measurement bay.
4.4 Platform/pit adapters
Adapters for attaching the sensors to a lifting platform
or pit.
i
For further information on the platform adapters,
refer to the following documents:
$
Fitting platform adapters (elevated) 1690706010.
$
Fitting platform adapters (under-floor)
1690706009.
$
Fitting pit adapters 1690706011.
¶
Fit the platform/pit adapters.
"
This completes fitting of the adapters.
4.5 Sensors
i
For further information on attachment and wiring of
the sensors, refer to the document Commissioning
of FWA 4630 1690706006.
1. Attach the sensors to the measurement bay.
2. Wire up the sensors.
"
This completes attachment and wiring-up of the sen-
sors.
Robert Bosch GmbH
Preparation for installation | FWA 4650 | 43
4.6 Trolley
i
For further information on start-up of the trolley,
refer to the document Commissioning of FWA 4630
1690706006.
1. Start up the trolley.
2. Connect the Bluetooth and WLAN adapter USB ex-
tension cables (2 x) to a PC/ Laptop.
3. Route the USB extension cables out of the trolley.
"
This completes start-up of the trolley.
4.7 Software and drivers
i
When commissioning wheel alignment units with a
manufacturer's PC/ Laptop, the user software (mea-
surement program, vehicle target data and drivers) is
already installed and configured.
i
When commissioning with a customer PC/ Laptop
or when retrofitting the WLAN-Box, the software +
drivers have to be installed and configured.
i
The software + drivers can be found on the fol-
lowing:
$
Measurement program CD
$
Vehicle target data DVD
$
Driver CD
$
USB data carrier (licence key)
i
The following drivers have to be installed for operati-
on of the hardware components in conjunction with
FWA 4650:
$
WLAN adapter
$
Bluetooth adapter
$
USB hardlock
i
The hardware components have to be connected
before or during driver installation when prompted
by the software:
Hardware Connection
components prior to
software
installation
WLAN adapter -
Bluetooth -
adapter
USB hardlock √
Tab. 9: Connection sequence for hardware components and
storage locations
!
Heed the connection sequence for the components.
en
Connection Storage
during location
installation
√ Driver CD
When
prompted
√ Driver CD
When
prompted
- Measurement
program CD
|
1 690 706 220 2014-01-31