Bosch FWA 4650 Erstinbetriebnahme Und Nachrüstung Seite 47

1 2
Fig. 10: Cable connections in the WLAN-Box
1 LAN cable (2 x) connections 3 + 4, left sensor
2 LAN cable (2 x) connections 1 + 2, right sensor
3 CCD reference system cable connection, left sensor
4 CCD reference system cable connection, right sensor
21. Attach the connecting cables (6 x).
Cable Sensors
2 x LAN Left
3D measurement system
Right
1 x Left
CCD reference system
1 x Right
CCD reference system
Tab. 13: Connections for WLAN-Box connecting cables
!
The LAN cables must be connected to the PoE so-
ckets of the switch.
22. Check the position of the WLAN router frequency
switch.
i
The frequency switch is located on the back of the
WLAN router in the WLAN-Box and can be used to
select the frequency of the WLAN link.
!
The WLAN frequency must be 5 GHz.
23. Re-attach the housing cover.
 This completes electrical installation of the
WLAN-Box.
24. Check the wiring to the sensors.
i
For further information on sensor wiring, refer to the
document Commissioning of FWA 4630 1690706006.
"
This completes electrical installation of the
FWA 4650.
Robert Bosch GmbH
Mechanical and electrical installation | FWA 4650 | 47
3 4
Component Socket
PoE switch PoE 3 + 4
PoE 1 + 2
Connecting Neutrik left
plate
Neutrik
right
5.2 Installation at cross member of
4-column lifting platform (suggesti-
on 2)
5.2.1 Fitting
i
WLAN-Box fitting procedure for front cross member
on 4-column lifting platform. Fitting location:
$
On top of cross member
$
On outside of cross member
$
On inside of cross member
1
Fig. 11: Suggestion 2 for fitting WLAN-Box on 4-column lifting
platform
1 Front cross member
2 Fitting location on outside of cross member
3 Fitting location on top of cross member
4 Fitting location on inside of cross member
en
2
3
4
|
1 690 706 220 2014-01-31