Bosch FWA 4650 Erstinbetriebnahme Und Nachrüstung Seite 63

Fig. 57: Service selection
8. Select the service.
9. Press the "Continue" button.
i
Service selection:
$
Service class = Serial port
$
Service name = Bluetooth Serial Port
Fig. 58: COM Port selection
10. Remove the tick against "Use standard COM port".
Robert Bosch GmbH
Installing Bluetooth adapter | FWA 4650 | 63
Fig. 59: Manual COM port assignment
11. Check whether there is a tick against "Automatic
connection".
12. Select COM port.
13. Press the "Continue" button.
!
COM port:
$
The COM port for the Bluetooth adapter must not
already be assigned.
$
The port should be in the COM Port 1-9 range.
$
The port should be in the range of the Bluetooth
ports (BT-Port) installed (refer to Checking).
i
COM port 1-9
$
On first starting, the measurement server (CCD
server) checks the COM ports 1-9 for a link with
the communication processor. If a link is found,
this port number is entered in the INI file of the
server and is used to establish the link.
$
Whenever the measurement server is started
afterwards, an attempt is first made to establish
a link by way of the port number entered in the
INI file.
If there is no link, the server scans the ports again
and updates the INI file.
!
If the communication processor is not at
COM port 1-9, a manual entry has to be made in the
INI file of the measurement server (refer to Service
instructions).
en
|
1 690 706 220 2014-01-31