Preparation For Installation; Unpacking; Fitting Monitor; Keypad (Special Accessory) - Bosch FWA 46xx + series Erstinbetriebnahme

en 20 | FWA 46xx+ | Preparation for installation
2.

Preparation for installation

2.1

Unpacking

Remove the packaging and transportation protection
from all the components supplied and dispose of these
in the prescribed manner.
2.2

Fitting monitor

i
Monitor assembly is described in the separate
instructions.
2.3

Keypad (special accessory)

1. Place the keypad in the keypad compartment.
2. Connect the keypad to the PC unit.
3. Fix the wiring in position with cable ties.
2.4

Connection to PC unit

!
Make sure the rubber grommet is correctly
positioned in the back wall to prevent cable damage.
i
Different LAN connectors: Make sure the round
connectors are routed to the sensor.
1. Remove the back wall from the cabinet.
2. Route the 4 LAN connecting cables and the two
cables for the measurement box through the back
wall and connect up in any order.
3. Connect the video cable to the PC unit.
4. Fix all the wiring in position with cable ties.
|
1 690 706 102 2018-03-28
2.5

Computer unit

(see operating instructions 1 690 706 143).
Robert Bosch GmbH