Herunterladen Inhalt Inhalt Diese Seite drucken

Safety During Use; Disposal - Heidolph Hei-TORQUE series Betriebsanleitung

Laborrührer
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Safety Instructions

Safety during use


➜ Wear the appropriate clothing when working on the device (protective clothing,
protective glasses and, if necessary, safety gloves).
➜ Do not use the device in potentially explosive areas. The device is not protected
against explosion. There is no explosion or ATEX protection available.
➜ Do not carry out work with naked flames in the vicinity of the device (risk of
explosion).
➜ Do not operate or assemble devices in the vicinity which are emission or radiation
sources (electromagnetic waves) for the frequency range (3*10
➜ Do not operate or assemble appliances in the vicinity of the device which constitute
emission or radiation sources for ionizing radiation or in the ultrasonic range.
➜ Do not operate the device where adiabatic compression or shock waves might occur
(shock wave combustion).
➜ Do not use materials which pose a potential risk of uncontrolled energy release which
might result in pressure increase (exothermic reaction; spontaneous combustion of
dusts).
➜ Only use impellers approved by Heidolph Instruments.
➜ Install all cables without kinks and outside the operating and danger zone.
➜ Avoid putting pressure on the display when you are not operating the device.
➜ Do not spill liquids over the device or any parts of it.
➜ Remove any accidentally spilled liquids immediatly.
➜ Eliminate errors immediately.
➜ Do not use abrasive material to clean the glass surface. Only wipe with damp cloth.
➜ Always switch the device OFF after use.

Disposal


➜ Check the device components for hazardous substances and
solvents.
➜ Clean all components before disposal.
➜ Dispose of the device in accordance with the relevant national
regulations.
➜ Dispose of the packaging material in accordance with the
appropriate national regulations.
Caution:
Possible damage to the environment
The device is equipped with a lithium button cell termed CR2032
by IEC-2. According to the european battery directive batteries
must be disposed off separately.
In case of disposal ensure, the waste diposal plant is either
member of the common redemption system for batteries or has
installed an individual redemption system according to the Battery
Directive 2013/56/EU.
9
11
15
Hz to 3*10
Hz).

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Hei-torque valueHei-torque precision

Inhaltsverzeichnis