Editing The Profile - Heidolph Hei-TORQUE series Betriebsanleitung

Start-Up

Editing the profile

You can edit up to seven profiles and save them as favorites.
The timer of each profile step always counts down to zero. This means
that each subsequent profile step must always be at least 1 minute
higher than the previous step. – Exception: Ending the profile cycle.
Example:
▪ 1 step: Time = 00:02
st
Rotation = 200
Ramp =
▪ 2 step: Time = 00:03
nd
Rotation = 400
Ramp =
▪ 3 step: Time = 01:00
rd
Rotation = 400
Ramp = l
➜ Open the submenu.
➜ Select the "Edit profile" menu item.
➜ Push the control knob and select the
rotation time by turning the control
knob.
➜ Push the control knob to confirm and
select the speed by turning the control
knob.
➜ Push the control knob to confirm
selection.
✓ The profile symbol is now displayed in
orange.
Ramp icon
▪ l
: The speed immediately ramps up to the pre-programmed rpm settings for the
pre-programmed time.
▪ /
: The speed increases (or decreases) gradually within the pre-programmed time
until it reaches the pre-programmed rpm setting.
➜ Choose your desired ramp by
turning the control knob clockwise or
counterclockwise.
➜ Push the control knob to confirm
selection.
✓ The positioning indicator jumps to the
next row.
➜ Enter the next ramp.
Speed increases to 200 rpm within 2 minutes.
l
Speed increases to 400 rpm between the 2
3 minute.
rd
l
Speed remains at 400 rpm between the 3
60 minute.
th
21
nd
rd
hh : mm rpm l
00 : 00
rpm l
0
00 : 02 l
l
00 : 02 200
l
00 : 02 200
/
00 : 02 200
00 : 02 200 /
hh : mm rpm l
and the
and the