4
REAR SHOCK ABSORBER REGULATION
A
In order to regulate the spring pre-loading,
use a sector wrench, on the regulating
metal ring B.
ATTENTION:
For the rear shock absorber regulation,
consider that the length of the spring with
standard pre-loading is of 194 mm.
ADJUSTING THE SLOW RUNNING
The slow running should be adjusted when
the engine is hot. Connect an electronic
revolution counter to the spark plug cable.
Tune up using adjusting screw A (idle
speed = 1,500 ± 100 rpm).
ADJUSTING THE THROTTLE PLAY
If the throttle control idle travel exceeds 3
mm as measured on the rim of the twist grip,
adjust the play by acting on adjuster B.
GB
59