Beta Motorcycles ALP 4.0 Bedienungsanleitung Seite 142

6
PROBLEM
Engine does not start
Clean the system
Engine knocks
Engine overheats and
loses power
Front braking poor
Rear braking poor
GB
CAUSE
- Fuel system clogged (fuel lines,
fuel tank, fuel cock).
- Air filter dirty.
- No current supplied to spark
plug.
- Engine flooded.
- Spark gap wrongly adjusted.
- Spark plug dirty.
- Spark advance excessive.
- Carbon formation in cylinder or
on spark plug.
- Silencer partly clogged.
- Exhaust port clogged.
- Ignition delayed
- Brake pads worn.
- Air or humidity in the hydraulic
circuit.
- Brake pads worn.
- Air or humidity in the hydraulic
circuit.
70
REMEDY
Clean the system.
Proceed as described on page 45.
Clean or replace the spark plug. If the
problem persists, contact a BETAMO-
TOR dealer.
Open the throttle wide and try starting
the engine for a few moments. If this
does not solve the problem, remove
the spark plug and dry it.
Restore the spark gap.
Clean or replace the spark plug
Check the ignition timing.
Contact a BETAMOTOR dealer
Contact a BETAMOTOR dealer.
Contact a BETAMOTOR dealer.
Check the timing
Follow the procedure described on
page 64.
Follow the procedure described on
page 40.
Follow the procedure described on
page 65.
Follow the procedure described on
page 41.