Beta Motorcycles ALP 4.0 Bedienungsanleitung Seite 115

Bleeding the rear brake
Follow these steps to bleed the rear brake
circuit:
• Remove rubber cap C.
• Remove the oil reservoir cap.
• Insert one end of a small tube into valve
D and place the other end in a container.
• Unscrew valve D (while pulling the brake
lever) and then pump by repeatedly
actuating the brake lever until oil starts
flowing out with no air bubbles. During
this operation, please do not let lever be
completely released and the brake pump
reservoir should be continuously refilled
to make up for the oil that is flowing out.
• Tighten the valve and extract the tube.
• Replace the cap.
43
3
C
D
GB