haNdlEBaR
The handlebar can be adjusted by rotating
it back and forth.
- To adjust the handlebar loosen screws 1.
- Position the handlebar according to
requirements.
- Tighten to the torque indicated.
ShOCK aBSORBER
adjuSTiNG ThE SpRiNG
pRElOad R10
To adjust the spring preload, use the pro-
cedure described below.
Rotate ring clockwise to increase the
spring preload (and consequently the
shock absorber preload) or anticlockwise
to decrease it.
For standard calibration, refer to page
15.
NOTE: for movement of the rings use a
specific sector key with square pin.
1
20Nm
29
3
1
GB