Receiving A Group Call During An On-Going Group Call; Transmit Inhibit - Motorola TETRA MTP850 Ex Bedienungsanleitung

• The terminal sounds a tone as explained in the note below.
• When receiving a High Priority Group Call, you will hear a
"High Priority Group Call" tone (if configured by your Service
Provider).
• When receiving a Group Call from your scan list, which is not
from a high priority group, you will hear a "New Group Call"
tone (if configured by your Service Provider).
• To block reception of a Group Call, select Optns then
Block. Powering off/on the terminal unblocks the reception
of this Group Call.

Receiving a Group Call during an On-going Group Call

Depending on how the Service Provider has configured
incoming calls, the incoming call will either be:
• Forced upon you and will interrupt the on-going call (if the
incoming call has higher priority than the on-going call).
OR
• Presented to you (if it has higher priority
than the on-going call).
• To accept the call, press Join
• To cancel the call, press End
Receiving an Emergency Group Call
For detailed information, see page 32.
Receiving a Broadcast Call
For detailed information, see page 33.

Transmit Inhibit

You can activate the Transmit Inhibit (TXI) Mode before
entering RF sensitive areas, e.g. in hospitals or in potentially
explosive areas, where safety can be jeopardized due to
MTP850 Ex/MTP810 Ex transmission radiation.
Radiation of the MTP850 Ex/MTP810 Ex is only suppressed if
the TXI Mode is activated or the MTP850 Ex/MTP810 Ex is
separated from power supply.
46
.
.
Join
Group In Use
TG4
ID: David
End