Receiving An Emergency Group Call - Motorola TETRA MTP850 Ex Bedienungsanleitung

If talk permit is granted to another member of
the group, an "Emergency call received" tone
will be heard. If configured by your Service
Provider, your MTP850 Ex/MTP810 Ex will
automatically attempt to get talk permit again
and the Wait For Mic message will be
displayed.
During this pending time the MTP850 Ex/MTP810 Ex
microphone is not active until the Emgcy Mic On message is
displayed again.

Receiving an Emergency Group Call

A terminal in TMO receives an Emergency Group Call to the
selected group, associated ATG (Announcement Talkgroup),
or scanned group. If the ATG is the currently selected group,
the terminal will receive the Emergency Group Call to the
group associated with this ATG. (For information on the ATG,
see page 39.)
When the MTP850 Ex/MTP810 Ex receives the call, the
display will show Emgcy In Use and the caller's identity.
If upon entering Emergency Mode, your MTP850 Ex/MTP810
Ex receives an Emergency call, and Hot Microphone was
enabled by your Service Provider, the Wait For Mic message
will be displayed. Your MTP850 Ex/MTP810 Ex will attempt
to get a talk permit.
The caller's voice will always sound via the speaker (unless
an external earpiece is connected to the terminal.
If configured by your Service Provider, the screen
background will be red.
Making an Emergency Private Call
1. Press and hold the Emergency button.
2. The terminal will start the call as a simplex or duplex call (as
programmed). The Emergency ID is pre-defined and it is
not displayed.
3. Continue the call as you would do in a simplex or duplex
call.
74
Emgcy In Use
ID:David
Wait For Mic
Optns End