Receiving A Group Call In Idle Screen With Scan Off; Receiving A Group Call In Idle Screen With Scan On - Motorola TETRA MTP850 Ex Bedienungsanleitung

Any incoming Group call is ALWAYS received through the main
speaker. If configured by your Service Provider, the Audio menu
item allows to setup the audio of the incoming Group Call.
If the setup is Speaker Control, you can direct the audio of an
active group to the earpiece (low audio) or the main speaker
(high audio). In low audio speak into the bottom microphone and
listen via the earpiece. In high audio speak into the top
microphone and listen via the speaker.
At the end of a call which has been directed to the earpiece, an
audio hang timer is activated, if it is enabled by your Service
Provider. Within the preprogrammed hang time, any incoming
call is still received through the earpiece. When the timer
expires, a low pitch tone is emitted alerting you that the next
incoming Group call will be received through the speaker. Upon
hearing this alert, you are advised to hold the terminal at a
comfortable distance away from the speaker.
When receiving a Group call, you will hear a "New Group Call"
tone (if configured by your Service Provider).

Receiving a Group Call in Idle Screen with Scan Off

You can receive a group call from the selected
talkgroup or from the associated ATG only.
Your MTP850 Ex/MTP810 Ex will receive the
Group Call.
Receiving a Group Call in Idle Screen with
Scan On
With Scan On, you can receive a group call
from the scan list you set up, in addition to
receiving a group call from the selected
talkgroup or from the associated ATG.
Receiving the scan call functions as receiving
an associated ATG or selected call in scan off
(see previous page), except for the following:
• The display is different when receiving the call in idle
screen, as shown here.
Group In Use
TG4
ID: David
Optns Folder
Group In Use
TG4
ID: David
Optns End
45