Turning Off The Tce 5330; Emergency Stop - Bosch TCE 5330 Originalbetriebsanleitung

en 38 | TCE 5330 | Operating instructions
10. Put the mounting tool close to the valve with the
special reference mark on the edge of the rim,
mount the clamp on the left of the mounting tool
whilst rotating the wheel clockwise and being sure
that the bead is in the drop centre of the rim.
i
If the mounting of the second bead should result
particularly difficult the pneumatic bead pressing
accessory can be used.
Mounting of wheels with bead wire
Bring the cover on the platform (lean it).
1. Bring the cover close to the rim by carrying out an
appropriate centring.
i
If the wheel has a tube, it has to be inserted in the
cover before mounting and it has to be deflated in
order to make it stretch uniformly inside the cover.
2. Use the bead breaking disk to carry out mounting of
the second bead.
3. Use the disk to insert the bead wire and then lock it
with the special locking ring.
i
If the tire is tubeless the special sealing ring has
to be inserted between the rim and the bead wire
(OR).
4. Put the valve in the special hole of the rim.
!
It is suggested to use inflation cages when inflating
wheels with a bead wire, because ejection of the
bead wire can cause serious damage to the operator
and to property.
!
WARNING! It is absolutely forbidden to carry out tire
inflation operations if the wheel is still mounted on
the machine!
|
1 695 301 841 2010-02-16
!
WARNING! Very heavy wheels have to be moved by
at least two persons!
5.4

Turning off the TCE 5330

To turn off the TCE 5330 once the tire mounting and
demounting operations have been carried out, press for
a couple of seconds the shut-down button; the remote
control and the electrical panel will shut down after ten
minutes.
i
The TCE 5330 shuts down automatically if it remains
inactive for more than 10 minutes.
5.5

Emergency stop

At any time, to stop the tire changer in case of emer-
gency, press for a couple of seconds the shut-down
button on the remote control or otherwise press the
emergency button on the electrical panel.
i
To restart the tire changer it will be necessary to
disable the emergency button (if still pressed) and
repeat the starting procedure.
Robert Bosch GmbH