First Start Up; Unpacking; Assembly; Machine Positioning - Bosch TCE 5330 Originalbetriebsanleitung

4.

First start up

4.1

Unpacking

1. Remove the packaging paying attention to nails
detaching.
i
After unpacking check the integrity of TCE 5330 and
check that no components are visibly damaged. In
case of doubt do not proceed to start-up and con-
tact a qualified technician and/or your vendor.
2. Take out of the transport crate the standard accesso-
ries and the packaging materials.
i
Dispose correctly of packaging material, hand it over
to the designated collection points.
4.2

Assembly

4.2.1

Machine positioning

1. Insert the appropriate lifting belts (length belt 1: 1.5
mt, belt 2: 2 m, with sufficient capacity, as shown.
Warning - tilting danger!
The barycentre of the TCE 5330 does not lie
in its centre.
€
It is necessary to lift the machine slowly.
Robert Bosch GmbH
First start up | TCE 5330 | 29
2. Lift the TCE 5330 with a lift crane and install it in
the designed area respecting the minimum distances
shown in the picture.
i
For safe and ergonomic use of the TCE 5330 it is
recommended to leave a minimum of 750 mm space
from the nearest wall and of 900 mm from the cei-
ling.
Warning - tilting danger!
During tire inflation considerable forces are
exerted.
€
The TCE 5330 has to be fixed in at least 3
points on the floor (screw holes see chap.
4.2).
en
|
1 695 301 841 2010-02-16