Bosch TCE 5330 Originalbetriebsanleitung Seite 37

4. Use the pedal to make the locking flange rotate and
in the mean time insert and lower the rim, pressing
on the on the cover bead in order to allow the upper
part of the rim to get into the tire.
5. While operating the tool movement control, rotate
the tool so that the disk faces the side of the tire
that has to be mounted and, by means of the same
control, lock the operating arm.
6. Press with the bead breaking disk the side of the tire
towards the rim drop centre and operate the pedal
to rotate without any interruptions the locking flange
until complete insertion of the tire on the rim.
7. If that is not possible, lock with the special clamp
(1) the part of tire that has already been fitted, then
use the working arm translation control to press with
the bead breaking disk the side of the tire towards
the drop centre of the rim and use the pedal to rota-
te without interruptions the locking flange until the
tire fits completely in the rim.
i
To mount particularly hard tubeless and supersingle
tires follow the instructions given for agricultural
wheels.
Robert Bosch GmbH
Operating instructions | TCE 5330 | 37
!
WARNING! It is absolutely forbidden to carry out tire
inflation operations if the wheel is still mounted on
the machine!
!
WARNING! Very heavy wheels have to be moved by
at least two persons!
Mounting of agricultural wheels
1. Lubricate with mounting paste both tire beads, the
shoulder and the drop centre of the rim.
2. Operating the working arm movement control, re-
lease the working arm.
3. Bring the cover on the platform (lean it).
4. Put the tire on the rim, mount the special clamp (1)
on the front edge of the rim.
5. Operate the pedal to rotate the locking flange until
the clamp has locked the tire, lift the wheel and
bring the clamp at 12 hour.
6. While operating the tool movement control, rotate
the tool so that the disk faces the side of the tire
that has to be mounted and, by means of the same
control, lock the operating arm.
7. While operating the working arm shifting control,
press with the bead breaking disk the tire bead
towards the drop centre of the rim and use the pedal
to rotate without interruptions the locking flange
until complete mounting of the rear bead.
1
8. Remove the clamp.
9. Introduce the tube (remember to lower the mandrel-
holding arm) and lean the wheel on the platform to
make mounting easier.
en
1
|
1 695 301 841 2010-02-16