Pneumatic Connection; Electrical Connection; Check Rotation Direction - Bosch TCE 5330 Originalbetriebsanleitung

en 30 | TCE 5330 | First start up
4.3

Pneumatic connection

1. Connect the TCE 5330 to the compressed air supply
unit.
2. Adjust to a pressure between 8 and 12 bar.
« Pull the red knurled screw (pressure reducing val-
ve) fi rst upwards and then twist it to adjust ope-
rating pressure.
« Check pressure on the manometer.
|
1 695 301 841 2010-02-16
4.4

Electrical connection

1. Check the correspondence of the mains tension and
the tension shown on the identification tag.
2. Ask a qualified electrician to mount a connection
plug for single-phase or (depending on the tension
you have ordered ) three-phase current (see the
electrical connections diagram inside the electrical
panel).
i
The costs of arranging a mains protection device for
the plug are borne by the customer.
3. Protect the TCE 5330 according to specific national
rules.
4.5

Check rotation direction

Warning - malfunctioning danger!
The TCE 5330 rotates counter-clockwise.
€
Turn off the main switch.
€
Check the part dedicated to functioning
anomalies to find the cause (see chap. 5.6)
For a correct functioning of TCE 5330 it is extremely
important that after having connected and started the
machine the rotation direction corresponds to that
shown by the arrow on the control unit motor.
Fig. 2: Check rotation direction.
Robert Bosch GmbH