Functions; Select Setting Level; Switching On And Off; Change Room Temperature - Truma VarioHeat Series Einbauanweisung

Functions

The functions in the menu bars (3, 4) of the Truma CP plus
VarioHeat control panel are selectable in any order. The op-
erating parameters are shown on the status bar (2) and on
the displays (5, 6).

Select setting level

– Tap the rotary push button.
The display shows the setting level. The first icon flashes.
Figure 7

Switching on and off

Switching on
– Tap the rotary push button.
Previously set values / operating parameters are reacti-
vated after switching on.
Switching off
– Press rotary push button for longer than 4 seconds.
The Truma CP plus VarioHeat control panel deactivation
procedure can be delayed by several minutes because of
internal heating or air conditioning system after-runs ("OFF" is
shown on the display during this time).

Change room temperature

– Select icon in menu bar (3) with rotary push button.
– Change to the setting level by tapping on it.
– Select between heating system (HEATER) or air condition-
ing system (AC) using the rotary push button, depending on
the unit connected.
– Tap rotary push button to confirm selection.
– Select desired temperature with rotary push button.
– Tap the rotary push button to confirm the value.
a b c
Figure 8
Heater (HEATER)
settable temperature range 5 – 30 °C (1 °C increments)
a = Heater on – Symbol lights up,
the symbol flashes until the room temperature is reached.
Air conditioning system (AC)
settable temperature range 16 – 31 °C (1 °C increments)
b = COOL – Air conditioning system is switched on
c = AUTO – Air conditioning system is set to automatic
d = HOT – Air conditioning system is in heating mode.
e = VENT – Air conditioning system is in air circulation mode
Quick temperature change using rotary push button poss-
ible (in stand-by screen).
d f e
2
3

Select fan level

With connected heating / air conditioning system
– Select icon in menu bar (3) with rotary push button.
– Change to the setting level by tapping on it.
– Select desired fan level with rotary push button.
– Tap the rotary push button to confirm the value.
a b
2
Figure 9
Heater (HEATER)
Icon Operating
mode
– OFF
a VENT
1
b ECO
d BOOST2
e NIGHT
1. Can cause greater motor wear, depending on the frequency of use.
Fan level "BOOST" results in higher power consumption, higher
2.
noise level and increased motor wear.
As soon as the heater is switched on (room temperature
selected), the status bar (2) displays the fan level that
was selected during the previous heating procedure. The fac-
tory setting is "ECO".
Air conditioning system (AC)
Icon Operating mode
– OFF
a –
b LOW
c MID
d HIGH
e NIGHT
f AUTO
c d e f
3
Description
Fan is switched off.
(only selectable if no appliance
is in operation).
Air circulation if no appliance is
in operation. 10 speed settings
available.
Automatic control of the fan, de-
pending on the heating power /
optimised to the current heating
requirement
Rapid room heating
Available if the difference be-
tween the selected and actual
room temperature is >10 °C
Heater running only at partial
load. Might not be possible to
reach the set room temperature
(depending on the vehicle size
and outside temperature).
Description
Fan is switched off
(only selectable if no appli-
ance is in operation).
–
Low fan level
Medium fan level
High fan level
Ultra-quiet fan operation
Automatic fan level selec-
tion. Cannot be changed in
AUTO mode.
21