Maintenance; Safety Recommendations; Routine Maintenance - GGP ITALY 102 Gebrauchsanweisung

6. MAINTENANCE

6.1 SAFETY RECOMMENDATIONS

WARNING!
Before cleaning or doing mainte-
nance work, take out the ignition key and read the rele-
vant instructions. Wear adequate clothing and work
gloves whenever your hands are at risk.
WARNING!
Never use the machine with worn or
damaged parts. Faulty or worn-out parts must always be
replaced and not repaired. Only use original spare parts:
The use or non-original and/or incorrectly fitted parts
will compromise the safety of the machine, may cause
accidents or personal injuries for which the
Manufacturer is under no circumstance liable or respon-
sible.
IMPORTANT
Never get rid of used oil, fuel or other
pollutants in unauthorised places!
WARNING!
All operations not described in chap-
ters 6.2 and 6.3 of this manual must be carried out by
your Dealer or a specialized Service Centre. Both have
the necessary knowledge and tools to ensure that the
work is carried out correctly without affecting the safety
of the machine.

6.2 ROUTINE MAINTENANCE

The table is to help you maintain your machine's safety and
performance. It summarises the main interventions to be made
and the frequency applicable to each of them.
The boxes at the side are for you to mark the date or number
of working hours at which the intervention was made.
Work
1. MACHINE
Check of tight fixing and sharpness of blades
2)
Blade replacement
2)
Check the transmission belt
2)
Transmission belt replacement
2)
Blade belt check
2)
Blade belt replacement
2)
Check and adjustment of brake
2)
Check and adjustment of drive
Check engagement and brake of blade
2)
Check all fastenings for tight fitting
3)
General lubrication
Front transm. oil level check (4WD model only)
Front transm. oil change (4WD model only)
1 1)
2. ENGINE
Engine oil change
Check and cleaning of air filter
Air filter replacement
Check fuel filter
Fuel filter replacement
Check and cleaning of spark plug points
Replacement of spark plug
1)
See the engine manual for the full list and frequency.
2)
At the first signs of any malfunction, contact your Dealer imme-
diately.
3)
General lubrication should also be carried out whenever the
machine is to be left unused for a long period.
4)
Change oil for the first time after the first 50 operating hours.
Hours (Date or N° of Hours)
2)
25
100
25
–
25
–
25
25
2)
100
25
25
2)
50
4)
200
.....
.....
.....
.....
.....
.....
.....
EN 29