Unpacking And Assembly; Fitting The Steering Wheel - GGP ITALY 102 Gebrauchsanweisung

3. UNPACKING AND ASSEMBLY

For storage and transport reasons, some components of the
machine are not directly installed in the factory, but have to be
assembled after their removal from the packing. Final assem-
bly is carried out by following these simple instructions.
IMPORTANT
The machine is supplied without engine
oil or fuel. Before starting up the engine, fill with oil and fuel
following the instructions given in the engine manual.
3.1 UNPACKING
When unpacking the machine, take care to gather all individual
parts and fittings, and do not damage the cutting deck when
taking the machine off the base pallet.
The packing contents:
– the machine;
– the battery;
– the steering wheel;
– the seat;
– the grass-catcher brackets;
– the grass-catcher components;
– an envelope containing:
– the operator's manuals and documents,
– the nuts and bolts including a pin for blocking the steer-
ing wheel,
– 2 starter keys and a spare 10 A fuse.
NOTE
To prevent damage to the cutting deck,
raise it to its maximum height and take utmost care when
taking the machine off the pallet. To make it easier to get
the machine off the pallet and to move it, the rear drive dis-
engage lever should be put in position «B» (
4WD model:
The machine can only be easily moved in reverse, even if
the rear drive is disengaged.

3.2 FITTING THE STEERING WHEEL

Put the machine on a flat surface and straighten up the front
wheels. Fit the steering wheel (1) onto the protruding shaft (2)
so that the spokes are correctly lined up.
Move the front wheels to turn both the shaft (2) and the steer-
ing wheel (1) about a quarter of a turn in order to get to the
hole (3) on the shaft.
1
4.33).
EN 9