Emptying The Grass-Catcher - GGP ITALY 102 Gebrauchsanweisung

The four different heights
of the wheels allows you
to maintain a safe dis-
tance between the cut-
ting deck edge and the
ground.
To change the position,
unscrew and remove the
screw (2) and reposition
the wheel (1) with the
spacer (3) in the hole at the desired height; then tighten the
screw (2) onto the nut (4) as far as possible.
WARNING!
This work is to be done to all four
wheels, WITH THE ENGINE OFF AND THE BLADES DIS-
ENGAGED.
To start cutting:
– put the accelerator into the «FAST» position;
– bring the cutting deck to the highest position;
– only use the blade ( 4.9), on grass lawns, do not use the
blades on stony ground or when the grass is very high.
– start moving forwards onto the grass area very gradually
and with particular caution, as already described;
– adjust the forward speed and the cutting height (
according to the lawn condition (height, density and damp-
ness of the grass).
WARNING!
When cutting on sloping ground, the
forward speed must be reduced to ensure safe condi-
tions ( 1.2 - 5.5).
4
3
2
1
In any case, the speed should always be lowered if you note a
reduction in engine speed, since a forward speed that is too
fast compared to the amount of grass being cut will never
mow the grass well.
Disengage the blades and put the cutting deck in the highest
position whenever you need to get past an obstacle.

5.4.6 Emptying the grass-catcher

Do not let the grass-catcher become too full as this may block
the collector channel. When the grass-catcher is full there is
an intermittent audible warning.
At this point:
– lower the engine speed;
– go into neutral (N) (
stop forward movement;
– engage the parking brake on
slopes;
– disengage the blades (
and the audible signal will stop;
Manual control
NOTE
4.8) Emptying the grass-catcher
can only be done with the
blades disengaged, other-
wise the engine stops.
– pull out the lever (1)
( 4.9.1) and tip up the
grass-catcher to empty it;
1
4.32) and
4.7)
2
EN 23