Tyre Pressure; Seat Adjustment - GGP ITALY 102 Gebrauchsanweisung

when the blades are engaged
– the parking brake is engaged without disengaging the
blades;
– the drive pedals ( 4.22 -
parking brake is on.
The table below shows various operating conditions, high-
lighting why the safety device shuts down the engine.
Operator Gr.-catcher Blades
A) PILOT LAMPS ON (Key in «ON» position)
Sitting YES Disengaged
Sitting NO Disengaged
B) WHEN STARTING (Key in «START» position)
Sitting Uninfluential Disengaged
Sitting Uninfluential Engaged
Absent Uninfluential Disengaged
C) WHEN CUTTING (Key in «ON» position)
Absent YES Engaged
Absent Uninfluential Disengaged
Absent YES Disengaged
Sitting NO Engaged
Sitting YES Engaged
5.3 DIRECTIONS BEFORE STARTING THE WORK
Before starting to work it is necessary to carry out several of
checks and operations to ensure that the work gives the best
results and is done in maximum safety.

5.3.1 Seat adjustment

The sliding seat can be adjusted into six positions.
4.32) are pushed when the
Transmission Brake Engine
«N» Engaged Stopped
«N» Disengaged Stopped
F / R Engaged Does NOT start
«N» Engaged Does NOT start
«N» Disengaged Does NOT start
Uninfluential Engaged Stops
F / R Disengaged Stops
«N» Disengaged Stops
Uninfluential Disengaged Stops
Uninfluential Engaged Stops
The position is changed by pulling up the handle (1) and slid-
ing the seat along to the notch of the position wanted.

5.3.2 Tyre pressure

Having the correct tyre pressure is the main condition for
ensuring that the cutting deck is horizontal and thus mows
evenly.
Unscrew the valve caps and connect a compressed air line
with a gauge to the valves and adjust the pressure to the indi-
cated values.
1,8 bar
1
1,4 bar
EN 19