Replacing The Heating Elements - Moretti Forni S100E Bedienungsanleitung

- Disconnect the thermostat faston connectors;
- Remove the thermostat dial (item 2 plate B);
- Unfasten the fixing screws of the heating element support;
- Remove the thermostat sensor located inside the compartment;
- Replace the thermostat (item 3 plate B) and the respective sensor.
- Perform the above operations in reverse order to reassemble.
5.4.3 REPLACING THE MAGNETIC DOOR FASTENER
After carrying out the operations described in 5.1 above, to replace the
magnetic door fastener proceed as follows:
- Open the doors of the leavening compartment (plate B);
- Remove the seal snap ring (plate B);
- Replace the magnetic door fastener (item 13 plate B).
5.4.4 THERMOSTAT DIAL REPLACEMENT
After carrying out the operations described in 5.1 above, to replace the
thermostat dial and/or relative ring nut, proceed as follows from the
outside of the compartment:
- Remove the snap-on thermostat dial (item 2, plate B).
- Replace the dial
5.4.5 INDICATOR LIGHT REPLACEMENT
After carrying out the operations described in 5.1 above, to replace the
indicator light and the light switch proceed as follows:
- Remove the casing for access to parts from the inside;
- Disconnect the indicator light faston connectors;
- Replace the indicator light (item 1, plate B).
- Perform the above operations in reverse order to reassemble.
5.4.6

REPLACING THE HEATING ELEMENTS

After carrying out the operations described in 5.1 above, to replace the
heating elements proceed as follows:
- Remove the casing for access to parts from the inside;
- Disconnect the heating element supply wires;
- Remove the heating elements (item 6, plate B);
- Perform the above operations in reverse order to reassemble.
6 LIST OF SPARE PARTS
Index of plates
Plate A Baking chamber assembly
Plate B Leavening compartment assembly
Plate C Steamer assembly
Plate D Wiring diagram cooking chamber
Plate E Wiring diagram leavening compartment
Plate F Electric diagram vapour aspiration hood.
INSTRUCTIONS FOR ORDERING SPARE PARTS
Orders for spare parts must contain the following information:
- Appliance type
- Appliance serial number
- Name of part
- Number required
UK/10