Basic Recording; Preparations - Yamaha DSP-AX2 Bedienungsanleitung

REC OUT allows you to record one source while viewing and/or listening to another source.

Preparations

STANDBY
/ON
SOURCE
DVD
MD/TAPE
D-TV/LD
CABLE
SAT
VCR 1
VCR 2/DVR
VIDEO AUX
REC OUT

Basic Recording

1 Turn on the power to this unit and all connected component.
1
2 Select the source component you want to record using REC OUT.
2
CD-R
TUNER
CD
PHONO
3 3 Start playback (or select a broadcast station) on the source component.
4 Start recording on the recording component.
4
Special considerations when recording DTS
software
The DTS signal is a digital bitstream. Attempting to digitally record the DTS
bitstream will result in noise being recorded. Therefore, if you want to use this unit
to record sources that have DTS signals recorded on them, the following
considerations need to be made.
For DTS encoded LDs, DVDs, and CDs:
Only 2-channel analog audio signals may be recorded as follows:
• LDs:
• DVDs:
• CDs:
• To record the current source, set REC OUT to SOURCE.
• To record a source that you do not want to reproduce, set REC OUT to the
source you want to record.
• If you want to listen to another source, and REC OUT is not set to
SOURCE, select the source you want to reproduce with the INPUT
selector and adjust the volume.
Notes:
• Do a test recording before you start an actual recording.
• When this unit's power is off, you cannot record between other component
connected to this unit.
• Operating BASS and TREBLE, BASS EXTENSION, BALANCE, VOLUME,
and DSP programs do not affect the recorded signal.
Set your Laser Disc player's left and right outputs to the analog soundtrack.
Use the disc menu to set the DVD player's mixed 2-channel left and right
audio outputs to the PCM or Dolby Digital soundtrack.
The DTS signal recorded on CDs can only be output as a digital bitstream,
and therefore cannot be recorded.
29