Selecting A Source - Yamaha DSP-AX2 Bedienungsanleitung

Basic Playback

Selecting a Source

INPUT
The selected source
D-TV/LD DVD
CABLE MD/TAPE
SAT CD-R
VCR 1 TUNER
VCR2/DVR CD
V-AUX PHONO
VOLUME
26
1 Select the source using the INPUT selector, or press one of the input buttons
1
on the remote control.
• The current source is indicated on the front panel display with an arrow.
• The current source name and input mode appear on the front panel display
and the video monitor for a few seconds.
Select this source:
DVD ........................................ DVD player
D-TV/LD ................................ LD player/Digital TV or TV
CABLE ................................... Cable TV
VCR 1 ..................................... Video deck 1
VCR 2/DVR ........................... Video deck 2 or Digital Video Recorder
V-AUX ................................... Other AV component
PHONO .................................. Turntable
CD ........................................... CD player
TUNER ................................... AM/FM tuner
MD/TAPE ............................... MD recorder/TAPE deck
CD-R ....................................... CD Recorder
SAT ......................................... Satellite tuner
2 2 Start playback (or select a broadcast station) on the source component.
• Refer to the operation instructions for the component.
3 Adjust VOLUME (or VOLUME +/– on the remote control).
3
Caution:
• If the power of the component connected to the VCR 1, VCR 2/DVR, MD/TAPE,
and CD-R OUT jacks is turned off, reproduced sound may be distorted or the
volume may be lowered. In these cases, turn on the component.
BGV (Back Ground Video) function
The BGV (Back Ground Video) function allows you to combine a video signal
from a video source with a sound signal from an audio source. (For example, you
can listen to classical music while you are watching a video.)
Using the remote control, select a source from the video group, then select a source
from the audio group. Use the input buttons on the remote control to make your
selections. The BGV function does not work if you select the sources using the
INPUT selector on the front panel.
To reproduce the signal
from this component.