Service Functions - Carl Valentin FLEXICODE Schnellreferenzhandbuch

Flexicode

Service Functions

NOTICE!
So that the distributor res. the manufacturer in case of service can offer fast support the necessary information such
as selected parameters can be taken directly from the service functions menu of the device.
Keys: , , ,
Photocell parameters
Key:
Paper counter:
Key:
Heater resistance
Key:
Printhead temperature
Key:
Ribbon
Key:
Print examples
Key:
Input
Key:
Output
122
, , , ,
H = cover switch (machines with cover switch only)
0 = open cover
1 = closed cover.
P = compressed air control:
Indication of 0 or 1 for the compressed-air control.
R1 = not used
R2 = transfer ribbon unwinding roll
Indication of transfer ribbon unwinding roll status.
4 states are indicated (no marking in photocell, marking from right, marking from left, marking
completely in photocell).
E = Encoder (continuous mode):
Indication of current state of encoder
C = Carriage:
Indication of print carriage position.
D: Indication of printhead attainment in meters.
G: Indication of device attainment in meters.
To achieve a high print quality, the indicated Ohm value must be set after an exchange of
printhead.
Indication of printhead temperature. The printhead temperature corresponds normally to the
room temperature. In case the maximum printhead temperature is exceeded, the current print
order is interrupted and an error message appears at the printer display.
Selection of the used transfer ribbon length (300 m, 450 m, 600 m).
Select this menu item to get a printout with all settings.
Settings:
Printout of all printer settings such as speed, label and transfer ribbon material.
Bar codes:
Printout of all available bar code types.
Fonts:
Printout of all available font types.
Indication of level for IO parameters input.
0 = Low; 1 = High
Indication of level for IO parameters output.
0 = Low; 1 = High
English
, , , , ,